Pop Up and Tilt Pedal Board in 1/4" Ply ATA Case - Unique! - 28 Inch

(3 reviews) Write a Review
Usually Ships in 5-10 business dasy
20.00 LBS
Free Shipping

This 28” pop up and tilt ATA pedal board case is incredibly useful for the musician who wants their equipment to work for them. It is simple to set up and can also be used as a standard pedal board case if you prefer not to use the "Pop Up & Tilt" feature. It comes completely out of the case without fasteners. The case itself is constructed of standard 3/8" plywood laminated to a heavy gauge Nubtex vinyl laminate with interior dimensions 28" x 14" x 4 1/2" high above the pedal board and 1 1/4" below the pedal board. The catches and rubber gripped handle are recessed. All aluminum extrusions are used to assemble the case with a Velcro friendly carpet lined interior. The case is approximately 7" high in the rear when set up and 2" high In the front. Optional dolly wheels and end handle available.

We ship to Hawaii & Alaska as well as internationally, but can only provide free shipping to the lower 48 US states at this time. Please email, call or text us for a quote for air, expedited, and international delivery options.

  • 1/4" Plywood Construction
  • Inside Dimensions: 28" x 14" x 4 1/4" high above the pedal board - 1 1/4" below the pedal board
  • ATA Construction
  • Nubtex Vinyl Laminate
  • Recessed Catches
  • Surface Spring Handle
  • 1 1/4" Space Under Pedal Board - 4 1/4" Above
  • Approx 2" High in Front
  • Approx 7" High in Rear (when setup)
  • Hold Down Blocks for Pedal Board When in Transit
  • Carpet Lined Interior
  • Made in the USA 

3 Reviews Hide Reviews Show Reviews

  • 5

    Posted by Spencer R Andrei on 11th Feb 2020


  • 5
    Case Quality

    Posted by Keith Bennett on 27th Jan 2020

    My third case and I love the pricing, quality and build of each one!

  • 4
    Pretty nice

    Posted by Fabian on 2nd Feb 2012

    I got my pedalboard and it looked very nice. After I set it up it looks even nicer. I like the construction and sturdiness. I wish the front panel was attached to the board with a hinged connector rather than a loose board that you need to prop. But, that is a small detail that does not detract from the board itself. The other wish I have is an angle selector for the board itself. The way it is set up the angle is a little steep. It would have been nice to have a way to make the angle smaller. Sure, I can cut the support board to the angle I want. Again, not a deal breaker by any stretched of the imagination.

    If I had to buy it again, I would. Also, I already recommended it to a few friends.